View Single Post
Old 07-20-2008, 05:19 PM   #1
murph_34a
Junior Member
 
Join Date: Feb 2008
Posts: 17
Default Size (Dimensions) Rejection Help

This is a new one for me. It says one of the sides is too narrow? I cropped it to 800px x 1000px. If I cut off more at the top or bottom it will change the ratio but I'm afraid it will make the edge uncomfortably close to the loco and the men working. If I make the vertical wider it will just either end up with more dead space to the right or more of the hood from the locomotive, which I think would take some of the emphasis away from the work being performed, which was the point of my shot. What does the forum think?

http://www.railpictures.net/viewreje...key=1069445462

At least a new rejection means a new learning experience.
Thanks
murph_34a is offline   Reply With Quote