Old 05-24-2012, 01:47 AM   #1
Bob Pickering
Senior Member
 
Bob Pickering's Avatar
 
Join Date: Dec 2003
Posts: 357
Default Oh that cropping thing.

I was RJ for bad cropping before I widened a bit had a couple other RJ for soft etc then cropping again (see below)

http://www.railpictures.net/viewreje...06&key=9930554

Now I trimmed top and bottom a bit and trimmed just a bit on the right and re subbed...but wannna see what you all think.

Thank You.

BP
Bob Pickering is offline   Reply With Quote
Old 05-24-2012, 04:26 PM   #2
Bob Pickering
Senior Member
 
Bob Pickering's Avatar
 
Join Date: Dec 2003
Posts: 357
Default

Well no luck on cropping so far...any advice?

One
http://www.railpictures.net/viewreje...08&key=7244720

Two
http://www.railpictures.net/viewreje...06&key=3923912

Maybe I need to go wider?

BP
Bob Pickering is offline   Reply With Quote
Old 05-24-2012, 05:01 PM   #3
bigbassloyd
Senior Member
 
bigbassloyd's Avatar
 
Join Date: Dec 2006
Location: Hilldale, West Virginia
Posts: 3,755
Default

I think you need to go wider on both sides (especially on the rejection where the engine is very close to the edge), and cut the bottom off just under the bridge on the left side.

Edit - also appears that vegas is leaning clockwise too.

Loyd L.
__________________
The screening standards here only extend 20 feet above ground level.

My personal photography site

Last edited by bigbassloyd; 05-24-2012 at 05:06 PM.
bigbassloyd is offline   Reply With Quote
Old 05-24-2012, 05:22 PM   #4
Bob Pickering
Senior Member
 
Bob Pickering's Avatar
 
Join Date: Dec 2003
Posts: 357
Default

I did wider and adjusted level and it got in! Thank You!
Bob Pickering is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT. The time now is 11:14 PM.


Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.